Study and Visualize RNA Translation Mechanisms at the Nanoscale

Part of: RNA Translation

Visualization of DNA-protein interactions

In this experiment, a DNA molecule is tethered between two beads while multiple fluorescently labeled proteins are interacting with it. We can visualize these interactions and track them over time using a multicolor confocal or STED fluorescence microscopy. The resulting kymograph unveils the number, position, diffusion and (un)binding events of the proteins along the DNA.

In this proof-of-concept experiment, the kymograph in figure 1 shows the position of bound XRCC4 and XLF on DNA over time at protein concentrations of 5 nM. These are two repair proteins involved in non-homologous end joining which can associate with each other to form complexes capable of bridging DNA. From the figure we can observe and quantify the dynamics (N=94 events) of XRCC4 (green, 9%), XLF (red, 62%) and XRCC4-XLF complexes (yellow, 29%).

The kymograph gives real-time insights in the DNA-protein interactions and protein-protein interactions involved in DNA repair. Simultaneous force and extension measurements allow correlating the protein activity and binding kinetics with the mechanical properties of the protein-DNA complex.

Kymograph showing the dynamics of XRCC4 (green), XLF (red), and XRCC4-XLF complexes (yellow) on DNA.

Data courtesy of Prof. Erwin Peterman and Prof. Gijs Wuite at the VU University Amsterdam.
Brouwer et al. (2016)

Investigation of ribosome activity and states

Here, an RNA molecule is tethered between two optically trapped beads and a ribosome translating it into a polypeptide. Next, we measure the activity of the ribosome as it translates the RNA template into protein. This is done by stretching the RNA with a constant force and simultaneously measuring the distance between the beads.

Figure 2 (top) shows the activity of a ribosome across an RNA molecule. As the ribosome translates the RNA fragment, it becomes shorter and the end-to-end distance between the two beads lessens proportionally. This enables us to measure the activity and states of translation proteins as well as the kinetics and formation of nascent proteins.

Also, the multicolour fluorescence detection allows quantifying the FRET efficiency changes of a labeled ribosome in time. In this way we can correlate a certain conformational change of the ribosome with its activity bursts (Figure 2, bottom).

2 Schematic showing the activity of a ribosome across an RNA molecule (top) and the corresponding FRET signal (bottom) across time.

Measurement of riboswitch conformational changes

Here, an RNA polymerase (RNAp) is caught and tethered between a bead and the nascent RNA strand. As the nascent RNA emerges from the RNAp the molecule begins to fold immediately forming riboswitches. We can follow the states and activity of the formed riboswitch, by stretching the tether with a constant force and measuring the distance between the beads.

Figure 3 shows the results of an experiment where we stretched and relaxed the RNA molecules with a constant load (10 nm/s, blue), while recording the force-extension curves. At approximately 8 pN we observe an unfolding rip, approximately 15 nm long. When we relaxed the molecule the refolding curve followed the same path as the unfolding, which corresponded to a rip of similar size. This shows that the unfolding of the RNA molecule is a reversible process. Cycles of unfolding and refolding could be repeated multiple times with the same result.

In the second experiment, we evaluated the structural transitions of our RNA target molecule over time. To this end, we brought a single RNA molecule to a specific pretension and studied its transitions. Figure 4 shows two major states at tensions around 6.2 pN and 7.2 pN, while a third conformational state was also occasionally accessed.

C-Trap RNA

3 Force-distance curves corresponding to the extension (red, 10 nm/s) and retraction (blue, 10 nm/s) of a single RNA tether.

C-Trap RNA Unfolding-2

4 Two-second time trace of a single RNA molecule held at an initial tension of ~7 pN. Dashed black lines show different possible visited states.

Sample courtesy of Prof. Hang Shi at Tsinghua University.


C-Trap® Optical Tweezers Fluorescence & Label-free Microscopy

Optical Tweezers and Fluorescence Microscopy

The C-Trap is the world’s first instrument that allows simultaneous manipulation and visualization of molecular interactions in real-time. It combines high-resolution optical tweezers, confocal microscopy or STED nanoscopy with an advanced microfluidics system in a truly integrated and correlated solution.

M-Trap® Optical Tweezers Fluorescence & Label-free Microscopy

Optical Tweezers

The m-Trap is the first entry-level optical tweezers instrument specifically developed for high-resolution single-molecule research. Ultra-high force resolution and stability, with incredible throughput, ease of use and modularity ‒ all at an unprecedented price level.

Key Product FeaturesC-Trap®m-Trap®
co-Localization studies
Conformational changes and states
Enzymatic activity that alters DNA/RNA mechanics (e.g. exonucleases, DNAp, helicases, SSB)
Single-molecule FRET studies
Rapid buffer exchange for fast experimental workflow
Visualization of binding position and diffusion of proteins

    Want to learn more?

    Would you like to receive exclusive news on the latest products, single-molecule events and breakthrough science from us?

    You can unsubscribe at any time from our marketing emails. By submitting the form you agree to LUMICKS' privacy policy.

    Newsletter pop up